PROJECTS · LK-ARTS

Electronics Sorting Box

AI visualization of the light grey electronics sorting box with a petrol sliding lid and organised components.

Original development · 3D printing

Electronics Sorting Box

Sort first, then solder. I use this box to organise circuit boards, modules and small components for a soldering project. One large and three small compartments keep the parts together. The sliding lid clicks into place as it closes.

Buy 3D print files CHF 6.50 · On Cults3D · Private use

AI visualization of the light grey sorting box with a petrol sliding lid and organised electronic components.
AI product visualization · Sorted components illustrate the intended use.

Prepare your soldering project

Place circuit boards and larger modules in the main compartment. The three smaller compartments keep connectors, screws, resistors or wires separate. The dividers are fixed.

The lid slides in two side guides. To open it, gently lift the latch and withdraw the lid using the fixed finger grips. The latch is an integral part of the printed lid.

The large compartment measures 110 × 136 × 42.6 mm inside. Each small compartment measures 84 × 44 × 42.6 mm. The closed box, including the latch and guides, measures approximately 214 × 145 × 51 mm.

The PLA fit test was printed and reported to fit perfectly. All three prepared print plates were sliced in Bambu Studio without slicer warnings. Use the included fit test to check sliding and latching before printing the full box.

LK-Arts developed the compartment layout for soldering projects, refined the sliding lid and prepared the print files. The design was created with AI assistance and CAD scripts.

Key facts

Category · Original design · Electronics

Files · 4 STL files, 3 Bambu Studio print plates and instructions in German and English.

Material and printing · PLA · Bambu X1 Carbon · 0.4 mm nozzle · 0.20 mm layers. Tray and lid are printed separately.

Buy 3D print files CHF 6.50 · On Cults3D · Private use

← Back to 3D projects